In this section:
The
Unable to show "metadata-from": No such page "_space_variables"
supports Rx interface which pertains to QoS resource reservation for reserving bandwidth in the IP access network. The Rx reference point is used to exchange application level session information between the Policy and Charging Rules Function (PCRF) and the P-CSCF. The Access Solution, acting as P-CSCF creates a TCP connection with the configured PCRF.Use the Diameter Node object to configure the Diameter Realm for external QoS requests on a per-IP TG basis.
Note
The SBC 52x0 and SBC 7000 systems support creating IP Interface Groups containing sets of IP interfaces that are not "processor friendly" (i.e. carried on physical Ethernet ports served by separate processors). However, restrictions exist regarding the usage of such Interface Groups.
(This ability does not apply to the SBC 51x0 and SBC 5400 systems which have only two physical media ports. IP interfaces from the two physical ports may be configured within the same IP Interface Groups without restriction.)
For complete details, refer to Configuring IP Interface Groups and Interfaces.
When configuring a Diameter Node in an HA configuration, the secondaryOriginHost parameter must be configured with the Standby hostname.
Do not configure PCRF on the Egress leg of the trunk group for REGISTER.
Command Syntax
% set addressContext <addressContext_name> operatorAggregatePolicer fillRate <fill_Rate#> bucketSize <bucket_size#>
Command Parameters
Diameter Node Parameters
Parameter | Length/Range | Description |
|---|---|---|
| ||
bucketSize |
Command Example
Example Diameter Node configuration:
% set addressContext ADDR_CONTEXT_1 diamNode diam ipInterfaceGroupName LIG1 ipV4Address 10.54.154.89 ipV6Address fe80::210:6bff:fe03:231 originRealm pcscf-open-ims.test primaryOriginHost katie secondaryOriginHost eleanor transactionTimeout 1500
Overview
Content Tools