Use the following steps to mount
Due to the size and weight of the SBC 7000 chassis, at least two people are required when lifting, mounting or unmounting the chassis.
Setting 19 4-Post Rack Mount
Using six of the supplied #10-32X5/16” flathead Philips screws (three screws per bracket), secure the front fixed mount brackets to the sides of the system.
Attaching Mount Brackets to the system
Install the rear mount support brackets on the sides of the system, extending the rear mount support brackets to 1” less than the measured depth of the rack, measured from the rear surface of the front fixed rack mounting bracket.
Use two to three of the supplied #10-32X5/16” truss head Philips screws for each bracket, depending on rack depth and hole alignment.
If your rack is especially deep, you may only be able to secure the rear mount support bracket using only two screws per side.
Installing Rear Mount Brackets on the sides
Lift the system to the desired location in the rack. If top location rack screws have been installed, align top clearance hole in the front mount rack bracket over screw head and install fully flush with rack, sliding screw into obround relief in the bracket.
Aligning the location of the rack
At the rear of the rack, insert the rear mount brackets into the rear mount support brackets and secure them to the rear of the rack using two of the appropriate screws on each bracket.
Inserting Rear Mount Brackets
Using four of the #10-32 X 5/16” truss head Philips screws (two per side), secure the rear mount brackets to the rear mount support brackets.
Securing Rear Mount Brackets