You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Back to Table of Contents

Back to Supported Features

Back to Session Recording Support

To support regulatory compliance and quality control purposes for call centers and financial institutions, the

Unable to show "metadata-from": No such page "_space_variables"
supports session recording by sending a copy of the RTP stream of the call to be recorded to an external recording device.

The

Unable to show "metadata-from": No such page "_space_variables"
does not participate in the decision process of which calls need to be recorded. Instead, it receives information about calls to be recorded via an enhanced SIP interface as defined by NICE Systems. NICE uses call ID, calling DN and UCID (Unique Call ID) to identify the recording session. This format supports Avaya recording.

The

Unable to show "metadata-from": No such page "_space_variables"
supports session recording functionality only if media is anchored in SBC. If direct media is applied, RTP streams do not flow through the
Unable to show "metadata-from": No such page "_space_variables"
, and the
Unable to show "metadata-from": No such page "_space_variables"
cannot duplicate RTP packets.

DN matching is performed based on “P-asserted-identity”, “p-preferred-identity”, “From” header or “To” header. This is configured at the SIP Trunk Group level using the ‘Recording DNpreference’ command.

The NICE recorder supports the following codecs:

  • G.711
  • G.729
  • G723_6.3
  • G723_5.3
  • G.722

Note

NICE and Media Packet Capture cannot be used simultaneously because the Splitter resource can only be configured for one feature.

To enable/disable a SIP Signaling Port to allow recording, use CLI syntax:

% set addressContext <addressContext_name> zone <zone_name> sipSigPort <index> recorder <disabled | enabled>

See Zone - SIP Sig Port - CLI or Signaling Ports - Sip Sig Port (EMA) for configuration details.

To enable/disable recording from SIP trunk group, use CLI syntax:

% set addressContext <addressContext_name> zone <zone_name> sipTrunkGroup <TG_NAME> media recordable <disabled | enabled>

See SIP Trunk Group - Media - CLI or SIP Trunk Group - Media (EMA) for configuration details.

 

  • No labels