In this section:
This section lists CLI commands to configure ingress IP attributes.
Command Syntax
% set profiles signaling ipSignalingProfile DEFAULT_H323 ingressIpAttributes flags convertProgressToAlert <disable | enable> dontSendFacilityMessage <disable | enable> refuseFastStartProposal <disable | enable> send183OnInitiatingDisconnectTreatment <disable | enable> sendFastStartResponseInCp <disable | enable>
Command Parameters
The IP Signaling Profile H.323 Ingress IP Attributes flags are shown below:
IP Signaling Profile H.323 Ingress IP Parameters
Parameter | Description |
|---|---|
| Set this flag to convert Progress messages to Alert messages when communicating to endpoints that have difficulty with Progress messages.
|
| Set this flag to prevent sending Facility messages to endpoints that do not tunnel and have difficulty processing Facility messages.
NOTE: Enabling this flag on the ingress leg may result in no media establishment for H.323 calls with discrete H.245 (no H.245 tunneling) due to H.245 socket collision. To avoid this issue, either disable this flag or ensure the H.245 signaling port address (actual hex value) associated with this setting is greater than its peer. |
| When this flag is set, Unable to show "metadata-from": No such page "_space_variables" does not include FastStart proposal in early media calls. Instead, it relies on H.245 procedure to complete media setup. When cleared, Unable to show "metadata-from": No such page "_space_variables" always includes fast start proposal in SETUP message for early media calls.
|
| Enable this flag to send a 183 message on initiating a disconnect treatment.
|
| When this parameters is used, the Unable to show "metadata-from": No such page "_space_variables" sends a Fast start response message in Call Proceeding messages.
|
Overview
Content Tools