You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Back to Table of Contents

Back to All

Back to All - Profiles

Back to Profiles - Media

Back to Media - Tone Profile

Specifies the attributes for Modulated tone configuration.

To View and Edit Modulated Tone

On SBC main screen, go to All > Profiles Management > Media > Tone Profile > ModulatedTone.

Select the desired Tone Profile from the drop-down list to view its respective Modulated Tone parameters.

The Modulated Tone window is displayed.

Profile Management - Media Profiles - Packet Service Profile - Tone Profile - ModulatedTone

The following fields are displayed:

Modulated Tone

Parameter

Description

Carrier Frequency

Specifies the frequency in Hertz of the carrier for the modulated signal. Value must be less than 4000.

If set to 0, then silence is generated. Only valid if generation method is modulatedTone.

Carrier Power

Specifies Carrier Power in dBm.

Power levels range from -50 dBm (minimum power) to +3 dBm (maximum power). Only valid if generation method is modulatedTone.

Signal Frequency

Specifies the frequency in Hertz of the sinusoid modulating the carrier sinusoid. Value must be less than 4000. Only valid if generation method is modulatedTone.

Signal Modulation Index

Specifies the modulation index of the signal.

Value must be in the range of 0 to 300 in 1% units. Only valid if generation method is modulatedTone.

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

  • No labels