You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Back to Table of Contents

Back to Administration

Back to Administration - Users and Application Management

Back to Users and Application Management - Radius Authentication

You can configure up to three RADIUS servers per SBC. When more than one RADIUS server is configured and RADIUS authentication is attempted, the server configured with the least priority value is tried first. If fallback is configured, the inverse priority order is followed to pick the next server for authentication. SBC allows a configurable number of retries and time-outs before retry.

To View Radius Server

On SBC main screen, go to Users and Application Management > Radius Authentication> Radius Server. The Radius Server window is displayed.

Radius Server

To Create Radius Server

To create a new Radius Server, click New Radius Server tab on the Radius Server List panel.

You can configure up to three RADIUS servers per SBC. New Radius Server tab is not available once three servers are configured.

Radius Server Fields

The Create New Radius Server window is displayed.

Radius Server Create Window

The following fields are displayed:

Radius Server Paramters

ParameterDescription
Server NameRADIUS server name (up to 23 characters).
Priority When configuring multiple RADIUS servers, use this attribute to specify the order to attempt RADIUS authentication. The RADIUS server with the lowest priority is contacted first.
StateOperational state of the RADIUS server. Options are
  • disabled (default)
  • enabled
Radius Server IP

IPv4 address of the RADIUS server. Default value = 0.0.0.0

IPv6 configuration for RADIUS server is not supported at this time.

Radius Server PortThe RADIUS server port to which the SBC sends the request. Range: 1-65535. Default value = 1812
Radius Nas IPIPv4 address of the SBC to send in ACCESS_REQUEST. Default value = 0.0.0.0
Radius Shared SecretThe shared secret used to encrypt the data exchanged between SBC and RADIUS server. Range: 8-128 characters
Mgmt Interface Group

The Management Interface Group that is used to connect to RADIUS server.

In a SBC HA configuration, four management IP addresses must be listed on the RADIUS server:

  • mgt0 and mgt1 IP addresses of the Active CE
  • mgt0 and mgt1 IP addresses of and Standby CE

To Copy Radius Server

To copy any of the created Radius Servers and to make any minor changes, click the radio button next to the specific Radius Server to highlight the row.

Radius Server Highlighted

Click Copy Radius Server tab on the Radius Servers List panel.

You can configure up to three RADIUS servers per SBC. Copy Radius Server tab is not available once three servers are configured.

Radius Server Fields

The Copy Selected Radius Server window is displayed along with the field details which can be edited.

Radius Server Copy Window

Make the required changes to the required fields and click Save to save the changes. The copied Radius Server is displayed at the bottom of the original Radius Server in the Radius Server List panel.

To Delete Radius Server

To delete any of the created Radius Server, click the radio button next to the specific Radius Server which you want to delete.

Radius Server Highlighted

Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Radius Server Delete Confirmation

Click OK to remove the specific Radius Server from the list.

  • No labels