In this section:
Use this profile to configure the SBC SWe active profile name using the built-in standard profiles.
When the SBC is deployed in a 1:1 scenario and registered with the RAMP, you must only configure the SWe Configuration Profiles through the RAMP or EMA.
This feature is only applicable when four or more vCPUs are configured.
An active profile cannot be deleted.
The active system (and standby system in HA configuration) system is rebooted. All active calls are lost during this process.
Standard profiles make some assumptions regarding the traffic model and, hence, may not be the optimal profile for the deployment of an I-SBC. To get the maximum capacity, create a custom traffic profile that matches the actual traffic input to the I-SBC. Refer to SWe Traffic Profiles - CLI.
For SBC SWe cloud-based deployments, the profiles are automatically configured based on the personality. Auto-configuring a profile prevents reboot during instantiation. The following table represents the SBC SWe automatic configuration:
Personality Type | Profile Name |
---|---|
I-SBC | default |
S-SBC | standard_signaling_profile |
M-SBC | standard_msbc_profile |
Command Syntax
The system sweActiveProfile
CLI syntax is shown below.
% set system sweActiveProfile name <profile name> default standard_callmix_profile standard_msbc_profile standard_passthrough_profile standard_signaling_profile standard_transcoding_profile standard_highcps_callmix_profile
Command Parameters
The following table lists and describes the standard profiles:
Profile | Description |
---|---|
default | By default, non-cloud I-SBC instances use the default profile. This profile supports a call mix containing a combination of 98% pass-through and 2% transcoding. |
standard_callmix_profile | This profile supports a call mix containing a combination of 90% pass-through and 10% transcoding calls. |
standard_msbc_profile | This profile is auto-configured on cloud-based M-SBC instances. This profile utilizes the vCPUs for pass-through calls. |
standard_passthrough_profile | This profile utilizes the vCPUs primarily for pass-through calls. |
standard_signaling_profile | This profile utilizes the vCPUs for signaling (direct media) calls and it is auto-configured on cloud-based S-SBC instances. |
standard_transcoding_profile | This profile utilizes the vCPUs for transcoding calls. |
standard_highcps_callmix_profile | This profile is similar to the standard pass-through profile, but with higher CPS. |
Command Example
Activate the standard_transcoding_profile
as the active traffic profile.
set system sweActiveProfile name standard_transcoding_profile commit The following warnings were generated: 'system sweActiveProfile': To Activate the Profile system will be rebooted.All active calls will be lost during this process. Do you wish to continue? Proceed? [yes,no]yes
For information on the procedure to activate a custom GPU profile, refer to the section "Configure GPU I-SBC on Openstack" section of the page Configuring SBC SWe in OpenStack Cloud Environment for GPU Transcoding.