You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

In this section:

Use this object to configure Backward Call Indicator (BCI) for Egress IP attributes.

To View and Edit Bci

On SBC main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Ip Signaling Profile > Egress Ip Attributes > Bci. The Bci window is displayed.

DEFAULT_H323

On the Bci window, choose the Ip Signaling Profile as DEFAULT_H323 to view the Bci fields for H323 Trunk Group.

Trunk Provisioning - Egress Ip Attributes H323 Bci

The following fields are displayed:

Egress Ip Attributes H323 Bci Parameters

Parameter

Description

Bci Interwork Encountered

Enable flag to indicate that ISUP is interworking with a network which is not capable of providing as many services as ISUP does. ISUP networks will therefore not employ certain features they otherwise normally would, including potentially the use of ISDN cause codes in failure conditions.

The options are:

  • disable (default)
  • enable
Bci Isdn Addess

Enable flag to enable ISDN Address in the BCI parameter of backward SS7 messages (e.g. ACM or ANM).

The options are:

  • disable (default)
  • enable

DEFAULT_SIP

On the Bci window, choose the Ip Signaling Profile as DEFAULT_SIP to view the Bci fields for SIP Trunk Group.

Trunk Provisioning - Egress Ip Attributes SIP Bci

The following fields are displayed:

Egress Ip Attributes SIP Bci Parameters

Parameter

Description

Bci Interwork Encountered

Enable flag to indicate that ISUP is interworking with a network which is not capable of providing as many services as ISUP does. ISUP networks will therefore not employ certain features they otherwise normally would, including potentially the use of ISDN cause codes in failure conditions.

The options are:

  • disable (default)
  • enable
Bci Isdn Addess

Enable flag to enable ISDN Address in the BCI parameter of backward SS7 messages (e.g. ACM or ANM).

The options are:

  • disable (default)
  • enable

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

 

  • No labels