You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

Overview

An SBC SWe deployment requires a VPC with sufficient IP space to support four or five IPv4 subnets:

  • Management (MGT0)
  • High Availability (HA0)
  • Packet 0 (PKT0)
  • Packet 1 (PKT1)
  • High-Availability-forwarding Engine Public Subnet (HFE Public-facing), depending on the deployment type

Using HFE

If you choose HFE, the following applies:

  • You must use a different private pkt0 subnet for each SBC HA pair. HA0, pkt1 and MGT0 subnets are sharable with other SBCs.
  • HFE templates create private pkt0 subnets for each SBC HA pair (when using the AWS_HFE_HA_template_auto_subnet.json template). 
  • You can create pkt0 private subnets before creating SBC and HFE. In this scenario, use HFE - AWS_HFE_HA_template.json to create an HFE HA pair with the subnets you provide.


If you choose to create private pkt0 subnets before creating SBC with HFE, consider the following:

Warning

You must create a different private pkt0 subnet for each SBC HA pair.


  • Private subnet – A subnet without any Internet GW attached to it, the routing table of the subnet can contain routing information only for VPC/subnets.

    • Example routing table for a private subnet:

      DestinationTarget
      10.54.0.0/16local
    • In the above example, no 0.0.0.0/0 rule is added to the routing table. Plus. there is no rule to send traffic to the Internet GW; only rule present here is "10.54.0.10/16 - local".
  • The suggested CIDR is /26 /27 (Using /24 or larger CIDR will waste many IP addresses)
  • Ribbon recommends using AWS_HFE_HA_template_auto_subnet.json to create the pkt0 private subnet while creating the SBC instance.  

Procedure

Create a subnet within an existing VPC, or allocate a new VPC. All four subnets must reside within the same region/VPC and availability zone.

To create a new subnet with CIDR x.x.x.x/20 within an existing VPC:

  1. Navigate to the VPC Dashboard: https://console.aws.amazon.com/vpc/


  2. Select Your VPCs on the left taskbar to see the list of VPCs available.


  3. Select Subnets on the left taskbar.
  4. Click Create subnet to create a subnet for MGT0 using a CIDR block. For example, x.x.0.0/20.


  5. Click Create subnet to create a subnet for HA0 using an IPv4 CIDR block, for example, x.x.16.0/20.
  6. Click Create subnet to create a subnet for PKT0 using an IPv4 CIDR block, for example, x.x.32.0/20.
  7. Click Create subnet to create a subnet for PKT1 using an IPv4 CIDR block, for example,  x.x.48.0/20.


  8. If deploying a High-Availability Forwarded Engine instance with the SBC, use a public-facing subnet. You can re-use an existing public-facing subnet. If not available, click Create subnet to create a subnet for HFE Public-facing using an IPv4 CIDR block, for example, x.x.64.0/20

For more information on creating subnets in AWS, refer to Creating a Subnet in Your VPC.

  • No labels