In this section:
ISDN to TLS SIP Server
Configure the Media and TLS profile for the ISDN to TLS SIP Server call:
1. Ensure there is a media profile for your preferred codec.
2. Review the Crypto Profile.
3. Verify the Media list for Media and Crypto Profiles.
4. Verify the TLS Profile.
In the SIP Server Table:
5. Add a SIP Server Host for the FE/SBA FQDN and set the TLS profile.
6. Set the SIP Options and the TLS Reuse Parameters.
In the destination Signaling Group:
7. Set the Media List entry.
8. Set the Federated FE/SBA FQDN and port:5067/protocol:TLS/TLS Profile.
9. Set the SIP Server Table entry.
Configure a call route from ISDN to the TLS SIP Server as follows:
1. Create a translation table/entry to perform any necessary number translations.
2. Create a Call Route entry. Configure the translation table name and Egress SG, enable transcoding, and configure the appropriate media list entry.
In the Ingress SG:
3. Verify/Set the Call Route Table and incoming ISDN port.
You will still need to configure the SBC for the appropriate certificates in order to complete TLS calls.