You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Next »

This section describes the steps for inserting and removing Interface Cards from the rear of the SBC 1000/2000 chassis.
Unknown macro: {multi-excerpt-include}

Removing an Interface Card

 

To Remove an Interface Card

  1. Power down the Ribbon SBC 1000/2000.
    Unknown macro: {multi-excerpt-include}
  2. Loosen the screws on the right and left side of the interface card until they spin freely.
  3. Depress the red buttons on the inside of the attachment levers until they click and lock into place. The Hot Swap status LED should now be lit.
  4. Grip the inside of the attachment levers and push toward the outside edges of the card.
  5. Carefully pull the card free of the chassis.

Remove Interface Card

 

Inserting an Interface Card

Unknown macro: {multi-excerpt-include}

To Insert an Interface Card

  1. Carefully insert the card so that the left and right edges slide into the mounting slots.
  2. Grip the outside of the attachment levers and push toward the inside of the card until the card locks into place.
    (info) The red buttons click and pop out when the card is properly locked into place.
  3. Tighten the screws on the right and left side of the interface card.

Insert the Card

Lock Card in Place

  • No labels