Consult the Microsoft documentation for the Direct Routing interface configuration guidelines, including the RFC standards and the syntax of SIP messages.
Requirements for configuring the SBC Edge in support of Teams Direct Routing include:
The SBC FQDN must be from one of the Domain names registered in “Domains” of the Tenant. The table below lists Domain Name examples.
Do not use the *.onmicrosoft.com tenant for the domain name.
Users may be from any SIP domain registered for the tenant. For example, you can configure user user@SonusMS01.com with the SBC FQDN name sbc1.hybridvoice.org, as long as both names are registered for the tenant.
Verify the correct domain name is configured for the Tenant. The correct domain name is required for the SBC to pair with Microsoft Teams.
The following section details the requirements for ports, protocols and services for firewalls in the path of Direct Routing calls.
Firewall settings may be referenced and applied at any time before, during or after the SBC configuration, but the settings must be applied before Direct Routing services take affect.
Ribbon recommends the deployment of the SBC Edge product (including the SBC SWe Lite) behind a firewall, within the DMZ, regardless of the assignment of a public IP to the SBC in question. Refer to SBC Edge Security Hardening Checklist for more information about the SBC and firewalls.
SIP TLS: TCP 5061*
DNS: TCP 53
DNS: UDP 53
NTP: UDP 123
SIP TLS: TCP 5061
Media: UDP 49152-53247
The tables below represent ACL (Access Control List) examples that protect the SBC Edge; these attributes are automatically provisioned if the Teams-related Easy Configuration wizards are used (applies to the greenfield deployment scenario only).
** Depends of the Media Port paired configured in SBC
Configure the Firewall per Basic Firewall Settings for All Call Flows, and then apply the updates below.
The Teams Client IP address cannot be predicted. As a result, allow Any IP (0.0.0.0/0).
Media for SBC 1000: UDP 17586-21186**
Media for SBC 2000: UDP 19386-28386**
Media: UDP 50000-50019
If the device that handles the NAT between the Teams Client and SBC Public IP is performing PAT (
), verify that this device has the source port range of the Teams Client media or open all the ports from 1024 to 65535.The tables below represent ACL (Access Control List) examples that protect the SBC Edge; these ACL attributes are automatically provisioned if the Teams-related Easy Configuration wizards are used (applies to the greenfield deployment scenario only).
** Depends of the Media Port paired configured in SBC