This object sets the preferred Time Zone for SBC.
During the installation process, the NTP server and time zone information is input to the Active server only. Once the Standby server starts, this information is synced from the Active to Standby.
The SBC supports up to three NTP servers.
The SBC should receive an initial time synchronization from NTP server before accepting calls.
To View Ntp - Time Zone
On the SBC main screen, go to Configuration > System Setup > Ntp > Time Zone. The Time Zone window is displayed.
Figure 1: Ntp - Time Zone
To Edit Ntp - Time Zone
To edit any of the Time Zones in the list, click the radio button next to the specific Time Zone name.
The Edit Selected Time Zone window is displayed below.
Figure 2: Ntp - Time Zone Edit
Make the required changes and click Save to save the changes.
The following fields are displayed:
Table 1: Time Zone
Parameter | Description |
---|---|
Name | Specifies the name of the System. |
Zone | Specifies the time zone under which the SBC node is present. For a list all the time zones, refer to Time Zones. |