You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Back to Table of Contents

Back to CLI Configure Mode

Back to Profiles - CLI

Back to Signaling - CLI

Back to IP Signaling Profile - CLI

Back to IP Signaling Profile - H.323 - CLI

In this section:

This section lists CLI command syntax to configure common IP attributes for communicating with the peer regardless of call direction.

Common Syntax

 

% set profiles signaling ipSignalingProfile DEFAULT_H323 
	commonIpAttributes 
		flags 
			audioCodecChangeThroughEmptyTcs <disable | enable>
			clearmodeForDataCalls <disable | enable>
			disableConstrainedCapacities <disable | enable>
			includeG729WithG729aWhenOfferPspHasG729a <disable | enable>
			sendEmptyTcs <disable | enable>

Command Parameters

The IP Signaling Profile H.323 Common IP Attributes are as shown below:

IP Signaling Profile H.323 Common IP parameters

Parameter

Length/Range

Description

audioCodecChangeThroughEmptyTcs

N/A

Enable flag to perform audio codec change (e.g. G.711 fax fallback) using empty Terminal Capability Set (TCS). When disabled, 

Unable to show "metadata-from": No such page "_space_variables"
performs audio codec change using request mode.

  • disable (default)
  • enable

clearmodeForDataCalls

N/A

Set flag to enable the clearmode function for data calls

  • disable (default) – If disabled for the SIP Egress call leg, legacy operation is signaled and payload type is assumed implicit (same on both sides). If disabled for the SIP Ingress call leg, legacy G.711 operation is accepted as well as Clearmode.
  • enable – If enabled for the SIP Egress call leg, Clearmode is sent using dynamic payload type. If enabled for SIP Ingress call leg, only Clearmode data calls are accepted.

disableConstrainedCapacities

N/A

Set this flag to present a full TCS to its peer during call setup or media modification. When disabled, 

Unable to show "metadata-from": No such page "_space_variables"
presents only the selected codec in the TCS, and follows up with a full TCS after media establishment.

  • disable (default)
  • enable

includeG729WithG729aWhenOfferPspHasG729a

N/A

Use this flag to control whether the H.323 Service Group includes G.729 along with G.729A in the network offer when the 

Unable to show "metadata-from": No such page "_space_variables"
offer Packet Service Profile has G.729A.

  • disable (default)
  • enable
sendEmptyTcsN/A

Enable flag to send empty TCS to the peer to restart the peer’s forward channel in case there is an address update in the direct media case.

  • disable (default)
  • enable

Command Example

% show profiles signaling ipSignalingProfile DEFAULT_H323 
 ipProtocolType h323; 
 commonIpAttributes { 
 flags { 
 audioCodecChangeThroughEmptyTcs disable; 
 disableConstrainedCapacities disable; 
 includeG729WithG729aWhenOfferPspHasG729a disable; 
 sendEmptyTcs disable; 
 } 
 }

  • No labels