In this section:
This section describes CLI syntax and parameters for the gwTrunkGroup 'callReservation' object used for reserving a portion of the resources for specific call direction or type for the specified gateway trunk group.
Note
As a best practice, always use UPPERCASE for trunk group names.
Command Syntax
% set addressContext <name> zone <name> gwTrunkGroup <name> callReservation inbound <0-100> incomingCallMinimum <0-128> outgoingCallMinimum <0-100> priorityCallMinimum <0-100> silc MC1Percent <0-100> MC2Percent <0-100> state <disabled | enabled> state <disabled | enabled>
Command Parameters
Call Reservation Parameters
| Parameter | Length/Range | Description |
|---|---|---|
inbound | 0-100 | The percentage of callLimit reserved for handling inbound calls (This is the percentage of channels reserved for handling inbound calls). Enter a value in 5 percent increments. (default = 0). |
incomingCallMinimum | 0-128 | Minimum number of incoming call allowed when reservations are enabled for this gateway trunk group. (default = 1) |
outgoingCallMinimum | 0-100 | Minimum percent of outgoing call allowed when reservations are enabled for this gateway trunk group. (default = 10) |
priorityCallMinimum | 0-100 | Minimum number of priority call allowed when reservations are enabled for this gateway trunk group. (default = 1). |
silc | N/A | Specifies the SILC traffic control configuration.
|
state | N/A | Administrative state to disable or enable the call reservation feature on a gateway trunk group.
|
Overview
Content Tools