Install and Configure EdgeView

To install and configure

1. Download the 

   Unable to show "metadata-from": No such page "_space_variables"
   artifacts install-ev.sh and ev-fullpkg.tar.xz to the /opt directory of your system (reach out to support@rbbn.com for the URLs of these artifacts):

   cd /opt/
   wget ftp://$url_from_support
   wget ftp://$url_from_support

2. Enable read-write-execute permissions for the copied files using the command given below:

   chmod +x install-ev.sh

3. Validate installation media readiness using the command given below:

   pwd && ls -alh

   
   As depicted in the example screenshot, confirm the two files exhibit approximately the same size and permissions. 

4. Execute the following command to start installation process:

   ./install-ev.sh

   The installation continues by installing Docker Compose, Docker and

   Unable to show "metadata-from": No such page "_space_variables"
   . Respond to  any prompts that arise.   
   The installation creates a log file of all actions for historical review/troubleshooting. The resultant filename is in the format of $MM-DD-YYYY-ev-install.log 

   You are prompted to enter information related to your networking configuration. Read this section carefully and enter the appropriate values applicable to your environment.
   Once installation completes, the console screen displays the message “ 

   Unable to show "metadata-from": No such page "_space_variables"
   Installation/Upgrade Completed ”. A directory named scc-build is created.

5. To check whether the containers started successfully, use the following command:

   docker ps --format "table 
   {{.ID}}\t{{.Image}}\t{{.Status}}\t{{.Names}}"

   Tip

   Make sure that the STATUS is healthy. If there are unhealthy statuses, run the following command and check the Health section of the output:

   docker inspect $container_name

   For example:

   docker inspect scc

6. Once the installation completes, optionally run a basic sanity check using the command given below:s

   cd /opt/scc-build ; ./ev_check.sh post-install

7. For initial SCC configuration, register your 

   Unable to show "metadata-from": No such page "_space_variables"
   server by accessing it through the web interface at its IP address and entering the registration information that you received in your email. If the registration information is not available, reach out to support@rbbn.com.

   Refer to Manually Configure ZTP when upgrading from

   Unable to show "metadata-from": No such page "_space_variables"

    15.2.0 or 15.2.1.

   

8. Enter the 
   Unable to show "metadata-from": No such page "_space_variables"
    admin registration details, and then click NEXT.
   
9. Enter the Tenant Admin registration details, and then click NEXT.
   
10. Click APPLY to complete the registration.
    
11. Click LOGIN to navigate to the login screen.
    
12. Enter the credentials and click SIGN IN to log in to 
    Unable to show "metadata-from": No such page "_space_variables"
    .