This section describes the Peer Surrogate Register Status window.


On the SBC main screen, go to Monitoring > Zone > Zone Specific > Peer Surrogate Register Status. The Peer Surrogate Register Status window is displayed.

Figure 1: Zone Specific - Peer Surrogate Register Status

By default only ten entries are displayed in a view. You can choose the number of entries to be displayed under the Show entries drop down box. 

The Peer Surrogate Register Status can be checked for each Address Context or for each Zone or for all the Address Contexts and Zones created. Use the drop-down box to select the desired Address Contexts and Zones.

The following fields are displayed:

Table 1: Peer Surrogate Register Status parameters

Parameter

Description

Peer NameSpecifies the name of the peer.
Surrogate Register State

This parameter is displayed only if the Surrogate Registration is configured at the IpPeer (i.e This parameter does not display if Surrogate Registration Profile is attached to an IpPeer.)

Specifies the surrogate Register State of the peer. The options are:

  • Active – Registration completes successfully.
  • Deleting – A de-registration was sent out and is awaiting final response from Registrar.
  • Inactive – Surrogate registration or re-registration has failed.
  • Initiating – A registration was sent out and is awaiting response from Registrar. Same state is also seen when refresh register is sent out or when register is challenged with 401/407 response and awaiting response from Registrar.
  • (No entries) – The surrogate registration flag is disabled or when de-registration has completed successfully.
  • No labels