Use this window to reset the contents of a selected IP policing offender list table.
On the SBC main screen, go to All > System > IP Policing. The Commands window is displayed.
Select Reset Offenders List from the Commands drop-down list and click Select. A pop-up window appears where you can select the Offenders List you want to reset.
resetOffendersList window
Select a list name and click resetOffendersList. The system returns a message confirming that the reset was successful.
Click OK to exit.
The following list names are displayed:
IP Policing Offenders Lists
List Name | Description |
---|
Bad Ether IP Hdr Offenders List | The table of statistics for the bad Ethernet/IP Header policer offenders list. For example: Only broadcast ARP packets are allowed; all other broadcast packets are considered bad. Only ICMPV6 neighbor discovery packets are allowed under multicast MAC address. Anything else is considered bad. If DestMAC is zero, it is considered a bad packet. Anything other than ethertype (IPV4, IPV6, VLAN) is considered bad. IP Checksum error. IP version other than 4 or 6 is considered bad. Bad IP Header length Packet that is not long enough to contain IP header. TTL == 0 is considered bad. IPV4 with options set is considered bad. IPV6 with initial next header field of 0, 60, or 43 is considered bad.
|
ARP Offenders List | The table of statistics for the ARP policer offenders list. |
U Flow Offenders List | The table of statistics for for the micro flow policer offenders list. For example:
- Microflow packet exceeding the policing rate.
|
ACL Offenders List | The table of statistics for access control (ACL) list policer offenders list. |
Aggregate Offenders List | The table of statistics for the aggregate policer offenders list. |
IP Sec Decrypt Offenders List | The table of statistics for the IPSec cecrypt policer offenders list. For example:
- Bad IPSec packet
- Authentication error
- Invalid SSID
- IPSec protocol == AH
|
Rogue Media Offenders List | The table of statistics for the rogue media policer offenders list. For example:
- UPD packets received in the media port range, but the destination UDP port is not allocated for media call.
- Media packets where source port, source address or destination address do not match.
|
Media Offenders List | The table of statistics for the media policer offenders list. For example:
- Media packets exceeding the policing value.
|
Discard Rule Offenders List | The table of statistics for the discard rule offenders list. For example:
|
Srtp Decrypt Offenders List | The table of statistics for the SRTP decrypt offenders list. For example: - SRTP packets which failed authentication or were flagged as replay packets
|
Additional topics: