In this section:

 

This screen helps you to understand the SDP Transparency control to set the SDP Transparency State flag to transparently pass SDP information.

To View and Edit SDP Transparency

On the SBC main screen, navigate to All > Address Context > Zone > SIP Trunk Group > Signaling > SDP Transparency.

SDP Transparency can be checked for each Address Context, for each Zone, for each Sip Trunk Group created or for all the Address Contexts, Zones and Sip Trunk Groups created. Use the drop-down box to select the desired Address Context, Zone and Sip Trunk Group.

The Edit SDP Transparency window is displayed.

IMPORTANT

Ribbon recommends using the Transparency Profile to configure transparency on the SBC Core Core for new deployments, as well as applying additional transparency configurations to existing deployments. Do not use IP Signaling Profile flags in these scenarios because the flags will be retired in upcoming releases.

Refer to the SBC SIP Transparency Implementation Guide for additional information.

 

SIP Carrier Peering - Signaling - SDP Transparency

 

 

The following fields are displayed:

Sdp Transparency Paramters

Parameter

Description

SDP Transparency State

Enabling this flag on both legs transparently passes SDP information. 

  • Disabled (default) 
  • Enabled

NOTE: Direct Media must also be enabled to use SDP Transparency for this call. Refer to SIP Trunk Group - Media for configuration details

 

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.