You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 45 Next »

Warning

The recommended hardware and software settings are intended to ensure optimum 

Unable to show "metadata-from": No such page "_space_variables"
stability and performance. If the recommended settings are not used, the
Unable to show "metadata-from": No such page "_space_variables"
system may not behave as expected.

This section describes

Unable to show "metadata-from": No such page "_space_variables"
hardware and software requirements and recommendations.

To install and configure

Unable to show "metadata-from": No such page "_space_variables"
, make sure the Virtual Machine (VM) host meets the following recommended hardware, server platform and software requirements.

SBC SWe for VMware – Server Hardware Requirements

Warning

The 

Unable to show "metadata-from": No such page "_space_variables"
software only runs on platforms using Intel processors. Platforms using AMD processors are not supported.

The following table lists the server hardware requirements:

Server Hardware Requirements


 ConfigurationRequirement
Processor

Intel Xeon processors (Nehalem micro-architecture or above) with 6 cores and above (processors should support hyper threading).

Note

Ribbon recommends using Westmere (or newer) processors for better SRTP performance. These processors have the AES-NI instruction set for performing cryptographic operations in hardware.

Note

The supported CPU Family number is 6 and CPU Model number must be newer than 26. Refer to the Intel Architecture and Processor Identification document for more information.

Note

ESXi 6.5 and later releases require approximately 2 physical cores to be set aside for hypervisor functionality. The number of VMs which can be hosted on a server must be planned for accordingly.

 RAMMinimum 24 GB
Hard DiskMinimum 500 GB
Network Interface Cards (NICs)

Minimum 4 NICs, if physical NIC redundancy is not required.

Note

Make sure NICs have multi-queue support which enhances network performance by allowing RX and TX queues to scale with the number of CPUs on multi-processor systems.

Note
  • The following NICs are supported for configuring as SR-IOV and DirectPath I/O pass-through devices. SR-IOV is supported only with 10 Gbps interfaces (x540/82599/x710):

Intel I350, x540, x550, x710 and 82599, Mellanox Connect - 4x, and Mellanox Connect - 5x. 

  • The VMware Enterprise Plus license is required for SR-IOV.
Ports

Number of ports allowed:


SBC SWe for VMware – Software Requirements

Warning

Using older versions of ESXi can trigger a VM instance shutdown. To prevent this from occurring, you must upgrade the VMware ESXi -- refer to the End of General Support column on https://lifecycle.vmware.com/#/ for supported versions.

The following are the

Unable to show "metadata-from": No such page "_space_variables"
 requirements for VMware ESXi environments:

VMware ESXi Requirements

VMWare ESXi Requirements

SoftwareVersionTested and Qualified VersionFor More Information
vSphere ESXi 6.0 or above
  • VMware 6.0 tested with VM version 11
  • VMware 6.5 tested with VM version 13
  • Customized ESXi images for various server platforms are available on VMware and hardware platform vendor sites.
    • These ensure that all the required drivers for network and storage controllers are available to run ESXi server.
    • Most of the customized ESXi images come with customized management software to manage the server running the ESXi software.
    • Customized ESXi images for HP ProLiant and IBM servers are available at:
vSphere Client5.1 or above
VMware Knowledge Base
vCenter Server5.1 or above
vCenter Server
Note

The VMware Enterprise Plus license is required for SR-IOV.

Third-Party References:


  • No labels