You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Back to Table of Contents

Back to Installing SBC 5400 Software

Back to Configuring the SBC 5400 Platform

Additional sections:

The BMC web application allows provisioning primary and secondary host management interfaces. When the host management interfaces are configured, a direct link from BMC is enabled to the EMA for installing and upgrading the 

Unable to show "metadata-from": No such page "_space_variables"
application.

Use the following procedure to configure the primary and secondary host management interfaces:

  1. Log on to SBC BMC GUI using the IP address configured in the previous section.

    username: root
password: superuser


    The BMC Main Screen appears:

    BMC Main Screen

  2. Click Configuration > Platform Management Network tab. The Platform Management Network Settings screen is displayed.

    Refer to SBC 5400 Media Ports and Operation Modes to know more about these four media ports and their operational modes.

    BMC Platform Management Network Settings Window

    A message appears to enter the management IP addresses for the first time installation.

    BMC PMNS Info Message

  3. Click OK.
  4. Configure the following network settings for all the four management interfaces from 0 to 3.

    - IPv4 Address or/and IPv6 Address

    - Prefix

    - Default Gateway

    BMC Platform Management Network Settings Window

  5. Click Save.

If you are updating a new Management IP address through BMC and click Save, reinstall the SBC application software (see the message appears in the below figure). Updating management IP using CLI/EMS/EMA will get updated automatically in BMC and re-installation is not required.

BMC Warning Message

 

 

 

 

 

  • No labels