You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Current »

Back to Table of Contents

Back to CLI Configure Mode

Back to System - CLI

In this section:

The mgmtStaticRoute object is used to configure static IP routes for the management interfaces. A static route indicates the nextHop gateway and management interface that is used for a particular peer network IP prefix.

A route preference may be configured for static routes as shown in the command syntax. The lower the preference value, the more likely the route will be used.

Command Syntax

% set system mgmtStaticRoute <destinationIpAddress> 
	<prefix>
	<nextHopIPaddress> 
	mgmtGroup <mgmtIntf1 | mgmtIntf2 | mgmtIntf3 | mgmtIntf4>
	preference <1-99>
 
% show system
	mgmtStaticRoute <destinationIpAddress> 
	<prefix>
	<nextHopIPaddress> 
	mgmtGroup <mgmtIntf1 | mgmtIntf2 | mgmtIntf3 | mgmtIntf4>
	preference <1-99>
 
% delete system mgmtStaticRoute

Command Parameters

Management Static Route Parameters

Parameter

Length/Range

Description

<destinationIpAddress>

N/A

The destination IP address (IPv4 or IPv6). This may be an Ethernet switch address, but must never be a symbolic IP address.

<prefix>

N/A

The IP prefix of this static route entry.

<nextHopIPaddress>

N/A

The IPv4 or IPv6 address of the next system enroute to the destination. Default value is 0.0.0.0.

mgmtGroup

N/A

Specifies the name of the management IP interface.

  • mgmtIntf1
  • mgmtIntf2
  • mgmtIntf3
  • mgmtIntf4

preference

1-99

Specifies the route preference, which is used by the lookup engine to decide the route entry to use if multiple equivalent routes exist to the same destination. By default, route preferences on active link interfaces take the values:

  • 1 – local route
  • 5 – direct route
  • 10 – static route

Command Example

To display management static route configuration:

% show system mgmtStaticRoute  
	mgmtStaticRoute 0.0.0.0 0 0.0.0.0 mgmtGroup mgmtIntf2 {  
		preference 10;  
	}  
	mgmtStaticRoute 0.0.0.0 0 10.34.26.1 mgmtGroup mgmtIntf1 
	{  
		preference 10;  
	}  
	mgmtStaticRoute 10.34.26.151 2 10.34.26.153 mgmtGroup 
	mgmtIntf1 {  
		preference 20;  
	}

  

In an environment with two subnet management 
Unable to show "metadata-from": No such page "_space_variables"
HAs, it is mandatory to add static routes referencing the management interfaces when creating a new management group.
  • No labels