In this section:

This section describes how to enable EdgeView control of SD-WAN. To enable control of SD-WAN via EdgeView, there are a few configuration prerequisites on EdgeMarc. Configure these changes as mentioned below.

SD-WAN License

The Ribbon Communications SD-WAN requires a license that should be purchased separately. This license is available as a subscription or perpetual license. Ensure that your SD-WAN is licensed, to be able to control it via EdgeView.

Enable WAN Link Redundancy

From the Configuration Menu, select Network > WAN Failover. Select Enable WAN Link Redundancy and Submit change.

Enable Traffic Shaping

From the Configuration Menu, select Network > Traffic Shaper. Select Enable Traffic Shaping and Submit change.

Note

To view EdgeMarc devices on the EdgeView Devices List page, configure the following parameters in the evagent.conf file:

EVAGENT_ENABLE=on
EDGEVIEW_HOST=”IP address”