Configuring the Direct Routing vSBA

This section outlines how to enable the Direct Routing vSBA and configure an IPv4 address.

1. Log into the WebUI of the SBC SWe Edge.

2. Click the Settings tab.

3. In the left navigation pane, select Virtual DR SBA > Virtual DR SBA Configuration.
   

4. From the Virtual DR SBA Enabled drop-down menu, select
   • Yes to enable the Direct Routing vSBA, or
   • No (default) to disable the Direct Routing vSBA.
5. If Virtual DR SBA Enabled is set to Yes, in the IPv4 Address field, enter the IPv4 address of the Windows VM that runs the vSBA software that this SBC SWe Edge should connect to.
   
6. Click Apply.