Call Data Records are generated as log files and contains the details of the call. It is a type of event logging. The behavior of the log file such as maximum file size, file count, rollover interval is controlled by CDR configuration.
For more information on SBC support of remote syslog servers and the supported log types, refer to Supported Log Types.
On the SBC main screen, go to Configuration > System Provisioning > Category: Base Provisioning > CDR > CDR Configuration. The CDR Configuration window is displayed.
Figure 1: CDR Configuration
The following parameters are displayed:
Table 1: set oam eventLog typeAdmin Parameters
Parameter | Length/Range | Description |
---|---|---|
| N/A | Specifies the type of event log being configured:
|
state | N/A | Specifies the requested state of the given Event Log type.
Accounting logs cannot be disabled. |
| 1-2048 | Specifies the number of event log files that will be maintained for this event type. (default = 32). |
| 256-65535 | Maximum size (in KB) that a single event log file will ever grow to. (default = 2048). |
Message Queue Size | 2-32 | The number of event log message entries to buffer before writing to disk. (default = 10). |
Save To | N/A | Use flag to specify that the events are saved to disk or not saved.
|
Filter Level | Events that are at least as severe as the designated level will be logged. Options are:
NOTE: The command to set the filterLevel for the acct event log is no longer applicable. | |
Rollover Start Time | N/A | Specifies the start time for event log rollover. The format is CCYY-MM-DDTHH:MM:SS . For example: 2010-01-01T01:01:01 |
Rollover Interval | 0-31536000 | Event log rollover interval, in seconds. |
Rollover Type | N/A | Event log rollover type. Options are:
|
Rollover Action | N/A | Event log rollover actions. Options are:
|
File Write Mode | N/A | Event log NFS write mode. Options are:
|
SysLog State | N/A | Enable flag to log events of specified type to syslog.
|
Syslog Remote Host | 0-255 | The remote host where the messages are written to the syslog. |
syslog Remote Protocol | N/A | The protocol to use to send messages to the remote syslog. Options are:
|
Syslog Remote Port | 1-65535 | Specifies the port to use to send messages to the remote syslog. Default value is 514. |
| Enable this flag to rename the most recent accounting file with “.ACT.OPEN” extension.
|
Enter all the fields and click Save.