DO NOT SHARE THESE DOCS WITH CUSTOMERS!

This is an LA release that will only be provided to a select number of PLM-sanctioned customers (PDFs only). Contact PLM for details.


In this section:

Related articles:

Gratuitous ARP - CLI

The SBC sends Gratuitous ARP with the 'opcode' reply to advertise the IP/MAC binding. Some routers support Gratuitous ARPs (GARPs) with the opcode 'request' by default. It is the recommended option for routers to send GARPs in response to ARP requests sent by any node in the same broadcast domain for address conflict detection, as mentioned in RFC 5227. In order to support the 'request' opcode and maintain backward compatibility, a configurable option to set the opcode for GARP based on the opcode supported by the router is available.

Configure GARP Opcode

Use the following procedure to configure the GARP Opcode.

  1. On the SBC mainscreen, go to All > System > Admin > Gratuitous ARP

    Edit Gratuitous ARP

    The default value for opcode is set to Reply (2). Set the Opcode as required.

GARP Parameters

Use the following table to edit the settings as needed, then click Save.

GARP Parameters

ParameterLength/RangeDefaultDescriptionM/O
Op Code

1- Arp Request

2- Arp Reply

Reply (2)

GARP opcode for

request and reply

Optional