Use the Signaling window to configure global-level signaling parameters.

To edit global signaling parameters:

  1. On the SBC main screen, navigate to All > Global > Signaling

  2. Use the following table to configure the options and then click Save.
    Global Signaling Parameters: 

    FieldDescription
    Teams Support

    Enable this flag to configure SIP Signaling for interfacing with MS Teams.

    NOTE: When you enable this global control, the SBC sends out both SDES and DTLS in the offer, if both are enabled in the Packet Service Profile. This might only be required if there is a Microsoft Teams client running in a browser.

    • Disabled (default)
    • Enabled
    Max Num TransfersSpecifies the maximum number of transfers (10-100) that the SBC allows within a call; default is 10.
    SIP IP Peer Stats

    Enable this flag to configure support for SIP IP Peer Statistics in the SBC.

    • Disabled (default)
    • Enabled
    Crank Back ProfileSelect a crankback profile to apply at the global level. For flexibility, crankback profiles can be assigned at three levels: trunk group, zone, and global. By default, the "default" crankback profile is assigned at the SBC global level, while the trunk group and zone level crankback profile settings are initially empty (" "). Thus in the SBC default configuration, trunk groups and zones inherit the default crankback profile from the global level. However, if you configure a profile at the trunk group or zone level, the user-specified profile assigned at the most specific level takes precedence.
 

Additional Sections:

Signaling - Diam Sig Controls
Signaling - Gw Sig Timers
Signaling - H323Sig Timers
Signaling - Sip Peer Overload Control
Signaling - SIP Sig Controls
Signaling - Srvcc
Signaling - Sig Only Mode
Signaling - Message Manipulation - Global