The following table lists the SBC feature license keys that apply in the network-wide domain license (NWDL) environment. NWDL license keys contain a suffix of "-D" to distinguish them from similar license keys used in node-locked licensing.

NWDL License Keys

Feature IDUsage

SBC-RTU-D

Controls the right-to-use (RTU) for SIP and H.323 sessions. The following type of media sessions are enabled:

  • Pass-through audio (no DSPs)
  • Pass-through audio and video (no conferencing)
  • Transcoded audio (DSP modules required).

SBC-SIP323-D

SIP/H.323 Interworking function.

SBC-POL-RTU-D

SBC Advanced ERE RTU per session license.

Note: If both "SBC-POL-E911-D" and "SBC-POL-ENUM-D" licenses are installed, the "SBC-POL-RTU-D" license is not required.

ENCRYPT-DEncryption function for signaling using TLS, IPsec.

SBC-SIP-I-D

SIP-I interworking function.

SRTP-D

Encryption function for media using secure RTP.

SBC-VIDEO-D

Video interworking support, including Content Sharing (BFCP), Far-End Camera Control (FECC) and H.239 for H.323

SBC-MRF-RTU-D

Required to enable transcoding using an external Media Resource Function (MRF) device. The SBC-MRF-RTU-D license is not a substitute for the SBC-RTU-D session license. Both the licenses are required to allow a session towards the MRF. The SBC-MRF-RTU-D license is only applicable to the S-SBC when deploying the distributed-SBC architecture.

DSP-SILK-D

RTU media interworking using SILK. Use license to enable SILK transcoding. (DSP modules required).
DSP-EVS-DRTU media interworking using EVS. Use license to enable EVS transcoding. (DSP modules required).

SBC-CAPACITY-D

Enables use of SBC features up to the capacity of the node. Actual license usage is reported to Ribbon using EMS statistics.

SBC-1X10GMP-D

SBC 5400 RTU license to enable media port(s) operating at 10 Gbps. This will activate two 10 Gbps packet ports.

SBC-4X1GMP-D

SBC 5400 RTU license to enable all four media ports. each operating at 1 Gbps.

Note: If the SBC 5400 is configured for two 1 Gbps media ports (default configuration), no license is required).

SBC-LI-D

Enables support for Lawful Intercept service using ERE.

SBC-POL-ENUM-D

SBC ERE support for accessing ENUM databases.

SBC-POL-E911-D

RTU license for E911 service.

DSP-G722-D ($0 charge)

RTU media interworking using G.722. Use license to enable G.722 audio transcoding. (DSP modules required) 

Note: Ribbon does not charge for the G.722 codec; however, the SBC 5xx0/7000 series code still checks for this license. Because of this, a $0 charge DSP-G722-D license must be generated and installed on SBC 5xx/7000 series in order to use G.722 features.

SBC-SIPREC-D

SIPREC session recording support.

SBC-NICEREC-D

Session recording using the NICE proprietary recording system.

VDSP-RTU-D

Enables transcoding feature in SBC SWe. If value is non-zero, it allows specified number of transcoded calls on the system. If zero, no transcoded calls are allowed.

VDSP-RTU-D count should be always less than or equal to SBC-RTU-D count. If not, no transcoded calls are allowed.

Note: Any additional emergency oversubscription is not supported for transcoded emergency calls on SBC SWe.

DSP-AMRNB-D

RTU media interworking using AMRNB. Use license to enable AMR-NB audio transcoding. (DSP modules required)

Note: Both DSP-AMRNB-D and VDSP-RTU-D licenses are required to transcode AMR-NB for SBC SWe.

DSP-AMRWB-D

RTU media interworking using AMRWB. Use license to enable AMR-WB audio transcoding. (DSP modules required)

DSP-EVRC-D

RTU media interworking using EVRC. Use license to enable EVRC audio transcoding. (DSP modules required)

Note: This license is not applicable to SBC SWe because EVRC is not supported.

DSP-SILK-D

RTU media interworking using SILK. Use license to enable SILK transcoding. (DSP modules required)

DSP-EVS-D

RTU media interworking using EVS. Use license to enable EVS transcoding. (DSP modules required)

SWE-INSTANCE-D

Required to run SBC software in an SBC SWe environment.
SBC-PSX-RTU-DRequired to use an external PSX system.