You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Back to Table of Contents

Back to CLI Configure Mode

Back to Address Context - CLI

Back to Zone - CLI

 

The disableZoneLevelLoopDetection flag controls when Zone-level Loop Detection is used for SBCs configured as EATF.

Note

This configuration is not supported on ERE and is intended for use only with an external PSX.

Command Syntax

% set addressContext <addressContext name> zone <zone name> disableZoneLevelLoopDetection <disabled | enabled> 

Command Parameter

Zone Disable Zone Level Loop Detection Parameter

Parameter

Description

disableZoneLevelLoopDetection

Use this flag for SBC configured as EATF to control when Zone-level Loop Detection is used.

  • disabled (default) – Global Loop Detection flag takes precedence over Zone Loop Detection.
  • enabled – Loop Detection is disabled for the specified zone.
  • No labels