Configuring SBC 7000 Host Network Management Interface

The BMC web application allows provisioning of primary and secondary host management interfaces. When the host management interfaces are configured, a direct link from BMC is enabled to the EMA for installing and upgrading the

Use the following procedure to configure the primary and secondary host management interfaces:

1. Log on to SBC BMC using the IP address configured in the previous section.
   
   Username: <username>
   Password: <default password>
   
   The SBC BMC main screen appears.

   BMC Main Screen

   

2. Click Configuration > Platform Management Network tab. The Platform Management Network Settings screen is displayed.

   Configuration Screen

   
   Note

   A message appears to enter the management IP addresses for the first time installation. 

   Warning Message

   
3. Click OK.
   
   

4. Configure the following network settings for both the Management Interface 0 and 1.
   
   - IPv4 Address or/and IPv6 Address
   - Prefix
   - Default Gateway
   
   

5. Click Save.

   Platform Management Network Settings

   
   
   Note

   When coming from an application software release prior to SBC 3.1.x, an IPv4-mapped IPv6 address is applied as an unusable placeholder in the IPv6 management address, this mapped address must be removed or set to a valid IPv6 address when updating the management addresses via BMC. 

   Note

   If you are updating a new Management IP address through BMC and click Save, reinstall the SBC application software (see the message appears in the below figure). Updating management IP using CLI/EMS/EMA will get updated automatically in BMC and re-installation is not required. 

   Warning Message