This feature applies to the SBC Cloud Native edition (CNe) only.
In this section:
After the OAM dashboard service activates, network operators must manually populate the Network Segment Table with IP address details. The Network Segment (NS) then retrieves the information from the Network Segment table (NST) through the config-agent.
The NS maintains the IP association details in a table termed Network Service Association table (NSAT), which is used during the switchover, or when the pod re-requests for an IP address using the same name.
The available command syntax is based on the chosen networkSegmentType
.
General Parameters (All Network Segment Types) The list of IPv6 names. Enter the network interface. The network segment type for this configuration. Modified: for 12.1.1 OAM-specific Parameter Specify the primary and secondary (as applicable) network name.Parameter Length/Range Description networkSegmentTable
1-23 <Name>
– The Network Segment Table name for the system.ipNameV4
1-23 <IPv4 list name>
– The list of IPv4 names containing the IP addresses and 'Start' and 'End' IP addresses. ipList <IP Address>
– Enter the list of IP addresses in space-separated format.ipRangeEnd
<Ending IP address>
ipRangeStart <Beginning IP address>
ipNameV6
N/A networkInterfaceName
N/A pkt0
pkt1
networkSegmentType
N/A OAM
– distributes configuration information to relevant pod instancesSC
– All types of Media (RTP and X3) land on SC directlySG
– When configured, enables the interfacing for non SIP signaling communication. SLB
– Acts as the single entry/exit point for all SIP Signaling to the SBC CNe.prefixV4
0 - 32 <V4 prefix>
– The IPv4 prefix for this Network Segment Table.prefixV6
0 -128 <V6 prefix>
– The IPv6 prefix for this Network Segment Table.vlanId
2 - 4094 <TAG>
– The VLAN TAG assigned to this Network Segment Table.Parameter Length/Range Description networkName
0-255 primary
– Enter the name of primary network. secondary
– Enter the name of secondary (port-redundancy case) network.
Code Block |
---|
admin@sbc set system networkSegmentTable nst1 prefixV4 24 vlanId 20 networkInterfaceName pkt0 networkSegmentType SC ipNameV4 range1 ipRangeStart 10.NN.NN.N ipRangeEnd 10.NN.NN.N |
Code Block |
---|
admin@sbc set system networkSegmentTable nst1 prefixV4 24 vlanId 20 networkInterfaceName pkt0 networkSegmentType SC ipNameV4 list ipList [ NN.NN.NN.NN NN.NN.NN.NN NN.NN.NN.NN NN.NN.NN.NN ] [ok][2021-05-25 08:39:07] [edit] admin@sbc commit Commit complete. [ok][2021-05-25 08:39:09] [edit] admin@sbc |