You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 24 Next »

In this section:

The T1/E1 PSTN Interface card is a TNV1 compliant digital interface card with integrated Channel Service Unit (CSU) function for direct connection to outside plant wiring. This card has board-mounted protection circuits for electrical isolation and protection against power crossing, lightning surges and hazardous voltages.

Card Port Versions

The T1/E1 PSTN Interface card offers 8 T1/E1 ports; the number of active ports is dependent upon licensing. For more information, see Node-Locked Licensing - SBC 1000/2000 and SBC SWe Edge. The 8-port card is shown below; all T1/E1 ports on the card have identical electrical circuit design.

T1/E1 PSTN Interface 8-port Card

#

Name

Description

1

Port 1-4 Status

Displays the status of ports 1 through 4.

2

Ports 1-4

Physical ISDN ports 1 through 4.

3

Port 5-8 Status

Displays the status of ports 5 through 8.

4

Ports 5-8

Physical ISDN ports 5 through 8.

5

Hot Swap

Displays Hot Swap status of the interface card.

Unknown macro: {multi-excerpt-include}

For more information on inserting and removing interface cards, see Inserting and Removing Interface Cards.


Port Status LEDs

Each T1/E1 port on the T1/E1 PSTN Interface card has an LED to indicate its operational status. The status states are described below:

Color

Status

Description

Off

No Signal

Indicates the port is not connected or connected cable is not providing a signal. Connect a cable or check the far-end connection.

Green

Link Up

Indicates the port is operating normally.

Red

LOF

Indicates the port has a Loss Of Framing (LOF) error. A cable is connected, but the

Unable to show "metadata-from": No such page "_space_variables"
cannot detect a correct T1 or E1 frame.

Amber

Yellow

Indicates there is a problem with the far-end connection. This status is usually communicated from remote side and indicates the 

Unable to show "metadata-from": No such page "_space_variables"
receiver is synced up, but there is a problem at the remote side receiver.

Hot Swap Status LED


Unknown macro: {multi-excerpt-include}

For more information about properly removing an Interface Card, see Inserting and Removing Interface Cards.


Dimensions and Weight

CardHeight mm/in. (PCB only) Width mm/in. (PCB only)Height mm/in. (Includes Connector overhang)Width mm/in. (Includes Connector overhang)Total Weight (lbs)
T1/E1 PSTN200.0/7.87275.0/10.83249.7/9.83307.5/12.110.8


Environmental Ranges (Operation and Storage)

Environmental Parameter

Specification

Operating Environmental Conditions

Temperature: 5º to 40º Celsius
Humidity: 5% to 85% RH non-condensing
Altitude: 60 meters below sea level to 1800 meters above sea level

Storage Environmental Condition

Temperature: -40º to 70º Celsius

T1/E1 Port Pinouts

The T1/E1 ports are connected to the public network using 4-wire shielded 26 AWG or larger twisted pair telecommunication line cords with RJ-48C or RJ-45 connectors.

T1/E1 Port Pinouts


T1/E1 Connector Pinouts

Pin NumberDescription
1

Receive Ring

2

Receive Tip

3

no connection

4Transmit Ring
5Transmit Tip
6no connection
7no connection
8no connection
  • No labels