The
Policy requests are distributed among active PSXs via the round robin process. When an active PSX becomes congested, the
The
This section provides examples of the steps an administrator uses from CLI and EMA to configure the
The external PSX pool maximum is increased to 40 as of Release 7.2.1.
CLI:
% set system policyServer localServer PSX_LOCAL_SERVER mode outOfService % show system policyServer localServer PSX_LOCAL_SERVER state disabled; mode outOfService; action dryUp; transactionTimer 2500; keepAliveTimer 5; retryTimer 2500; retries 1;
On SBC main screen, navigate to Configuration > System Setup > Policy Server > Local Server. The Local Server window is displayed.
Figure 1: Local Server
CLI:
% set system policyServer globalConfig reconnectTimeout 10 switchOverMode automatic congestionControl enabled type mgmt mgmtInterfaceGroup mgmtGroup % show system policyServer globalConfig reconnectTimeout 10; switchOverMode automatic; congestionControl enabled; type mgmt; mgmtInterfaceGroup mgmtGroup
On SBC main screen, navigate to Configuration > System Setup > Policy Server > Global Config. The Global Config window is displayed.
CLI:
% set system policyServer remoteServer PSX1-A ipAddress 10.20.123.12 state enabled mode active % show system policyServer remoteServer PSX1-A ipAddress 10.20.123.12; state enabled; mode active;
On SBC main screen, navigate to Configuration > System Setup > Policy Server > Remote Server. The Remote Server window is displayed
CLI:
% set system policyServer remoteServer PSX1-B ipAddress 10.20.123.13 state enabled mode standby % show system policyServer remoteServer PSX1-B ipAddress 10.20.123.13; state enabled; mode standby;
On SBC main screen, navigate to Configuration > System Setup > Policy Server > Remote Server. The Remote Server window is displayed
alternate
".CLI:
% set system policyServer remoteServer PSX2-A ipAddress 10.20.123.14 state enabled mode alternate % show system policyServer remoteServer PSX2-A ipAddress 10.20.123.14; state enabled; mode alternate;
On SBC main screen, navigate to Configuration > System Setup > Policy Server > Remote Server. The Remote Server window is displayed.
For a complete list of commands and parameters, please refer to either the CLI Reference Guide or EMA User Guide.