You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Back to Table of Contents

Back to CLI System-Level Mode

Back to show Command Details

Back to show status Command Details

In this section:

Command Syntax

 

> show status oam
	accounting
		cdrServer status
		radius radiusServerStatus
	alarms
		ethernetCrcErrAlarmStatus
		ipPolicingAlarmStatus
		mediaSrtpErrAlarmStatus
	eventLog
		confdDebugLevel
		filterStatus
		typeStatus
	localAuth userStatus
	snmp community

Command Parameters

The following objects are included in this table for completeness, but only apply when using the  show table system command. Additionally, and administrative statistics shown below do not apply to 'show status oam' command.

ema, radiusAuthentication, traps

MultiExcerpt named OamParams was not found -- Please check the page name and MultiExcerpt name used in the MultiExcerpt-Include macro

 

Command Example

 To display status of OAM SNMP objects:

> show status oam snmp community engineId 
engineId 80:00:0b:3f:03:00:10:6b:02:c7:ef;

To display the status of OAM Eventlog objects:

> show status oam eventLog typeStatus security 
currentFile 1000006.SEC; 
fileRecords 6; 
fileBytes 986; 
totalFiles 31; 
totalFileBytes 10955; 
memoryRecords 0; 
memoryBytes 0; 
filesDropped 0; 
memoryDropped 0; 
nextRollover 0; 
logDestination localDisk; 
lastFileDrop 0000-00-00T00:00:00Z; 
lastMemoryDrop 0000-00-00T00:00:00Z;

Error Messages

When NP 0 error counter messages are received in the DBG logs, the Ethernet Switch configuration (Datalink Device L2) is checked. If the Switch is overloaded with traffic,

  • The total drop count on the particular Interface on the Switch must be checked.
  • The Switch side configuration must be corrected.

Every Switch vendor has their own command to display the drop counts. Therefore, the respective document must be checked to check the drop counts.

 

  • No labels