Deploying an F5 Load Balancer in a PBX-SBC-Lync Topology

This article describes the steps necessary to configure the

The elements used in this topology are as follows:

• 2x Microsoft Lync 2010 front end servers
• 1x F5 Networks hardware load balancer
• 1x Meridian PBX
• 1x 
  Unable to show "metadata-from": No such page "_space_variables"

For more details regarding the F5 load balancer configuration and Lync integration, please review the F5 Hardware Loadbalancer (HWLB) Configuration section. You may also jump directly to the Ribbon SBC 2000 Configuration and Call Flows sections.

F5 Hardware Loadbalancer (HWLB) Configuration

For the purpose of this article we assume that the F5 load balancer is installed and configured such that it is already successfully integrated with Lync 2010. For details regarding the configuration and integration of an F5 load balancer see the following F5 documents:

• BIG-IP Virtual Edition Setup Guide for VMware ESX or ESXi
• Deploying the BIG-IP LTM with Microsoft Lync Server 2010

Load Balancer Configuration Hints

1. Using the DNS Manager, verify that the Lync 2010 Enterprise Pool Alias is pointing (therefore resolving) to the IP address of the hardware Load balancer machine as shown below.

   DNS Manager

   

2. Verify that the VLAN interface used to communicate with the Lync server is tagged as indicted below.

   Tag VLAN Interface

   

3. Verify that the F5 MGMT IP address is configured to use the VLAN interface set in the previous step.

   Verify Configuration of F5 MGMT IP Address

    

4. Verify that the VLAN interface Settings are configured as shown below.

   Verify Configuration of VLAN Interface Settings

    

5. Verify that Local Traffic > Nodes settings contain the Lync FE1, Lync FE2, and the virtual IP address of hardware load balancer machine as shown below.

   Verify Node Settings

   

6. Verify that the settings found in Local Traffic > Pools contain the pools that the F5 load balancer listens to Lync on defined port numbers for various services as shown below.

   Verify Pool Settings

   

    

   NOTE: the details of pool creation is explained in Deploying the BIG-IP LTM with Microsoft Lync Server 2010as shown below.

   Details of Pool Creation

   

7. Verify the virtual server making use of the pools created above has itself been created as shown below.

   Verify Virtual Server

   

Unable to show "metadata-from": No such page "_space_variables"

 Configuration

The

• Federated IP/FQDN: Pool FQDN in the IP/FQDN field
• Netmask: 255.255.255.255 in the Netmask field
  
  These fields allow the
  Unable to show "metadata-from": No such page "_space_variables"
   to receive SIP messages from the hardware load balancer HWLB. However, in order to receive/send SIP messages to/from Front End Servers, the Netmask field must be configured with a value of 255.255.255.0.
  
  

Ribbon SBC 2000 Configuration

 

Call Flows

Using the Log Exchange utility, you can verify the F5 Hardware Load Balancer (HWLB) in action —

PSTN ph >

Unable to show "metadata-from": No such page "_space_variables"

> Lync client

The deployment in this article allows the following call flow in PSTN ph >

PSTN ph > Lync Client Call Flow

LYNC client >

Unable to show "metadata-from": No such page "_space_variables"

 > PSTN ph

The deployment in this article allows the following call flow in Lync client >

Lync Client > PSTN ph