You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Current »

 

Use this window to specify SBC handling when modem tones are detected.

To View and Edit Modem Options

On the

Unable to show "metadata-from": No such page "_space_variables"
 main screen, go to Configuration > Profile Management > Category: Media Profiles > Codec Entry > Modem. The Modem window is displayed.

Select the desired Codec Entry from the drop-down list to view its respective modem parameters.

Profile Management - Media Profiles - Codec Entry - Modem

Use the following table to configure the options and then click Save.

Codec Entry - Modem Parameters

Parameter

Description

Failure Handling

Specifies the behavior when a modem tone is detected but the treatment fails for any reason. The behavior can be:

  • Disconnect—Release the call.
  • Continue (default)—Continue to process the call.

 

Tone Treatment

Specifies the treatment taken when modem tones are detected, which can be:

  • None (default)—Do nothing when modem tones are detected.
  • Notify Peer—Notify the peer when modem tones are detected.
  • Disconnect—Disconnect the call when modem tones are detected.
  • Fallback To G711—Fall back to G.711 when modem tones are detected.
  • Apply Fax Treatment—Treat the modem tone as a fax tone, and apply the fax treatment for the selected codec.

 

Honor Tone Detection

Enable this option for G.711 to G.711 transcoded calls to cause the SBC to initiate a re-invite upon modem tone detection when the modem Tone Treatment configuration is Fallback To G711.

When disabled, the SBC ignores the modem tone.

  • Disable (default)
  • Enable

This option only applies to a G.711 codec without silence suppression.

Note:

For G.711 calls, Notify Peer and Disconnect require a compression resource to be allocated.

 

  • No labels