You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Back to Table of Contents

Back to Configuration

Back to Configuration - System Provisioning

Back to Category - Base Provisioning

Additional section:

In this section:

A zone is used to group a set of objects unique in a particular customer environment. You can configure at most only one SIP signaling port or H.323 port in a zone. A zone can also be referenced by a SIP or H.323 trunk Group.

Note

Trunk group names must be unique across all address contexts, zones, and trunk group types. 

Note

IP peer names must be unique across all address contexts, and zones.

To View Zone

On SBC main screen, go to Configuration > System Provisioning > Category: Base Provisioning > Zone. The Zone window is displayed.

System Provisioning - Zone

The Zone can be checked for each Address Context or for all the Address Contexts created. Use the drop-down box to select the desired Address Context.

Zone Main Field

To Edit Zone

To edit any of the Zones in the list, click the radio button next to the specific Zone name.

Zone Highlighted

The Edit Selected Zone window is displayed below.

Zone Edit Window

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

To Create Zone

To create a new Zone, click New Zone tab on the Zone List panel.

Zone Fields

The Create New Zone window is displayed.

Zone Create Window

The following fields are displayed:

Zone Parameters


Parameter


Description

Name

Specifies the name of the zone. Must be 1-23 characters. The value ranges up to 23 characters.

Zone name is unique across all address contexts.

ID

Unique ID of this zone. The value ranges from 1 to 4096.

Zone ID is unique across all address contexts.

Disable Zone Level Loop Detection

  • If disabled, Global Loop Detection flag takes precedence.

  • If enabled, Loop Detection is disabled, irrespective of Global Loop Detection flag.

DNS Group

The name of the DNS group. Select the DNS group from the drop-down list.

Remote Device Type

Specifies the type of device facing this Zone. The options are:

  • accessDevice
  • appServer
Domain NameSpecifies the name of the fully qualified domain name for this Zone. The value ranges up to 63 characters.
SIP Register Relay

Enable flag to relay REGISTER using the routes from PSX. Options are:

  • Disabled
  • Enabled
Dialog Transparency

This parameter specifies if dialog transparency is enabled for SIP messages processed in that zone. If enabled, SBC sends "Call-ID", "From" tag, and "To" tag transparently in the outgoing message.

The parameter Dialog Transparency must be enabled in both the ingress and egress zones.

To enable Dialog Transparency for a zone, first disable all Sip Sig Port for that zone.

Flexible Policy Adapter Profile

Use this Zone/Trunk Group parameter to associate a Sip Adapter Profile configured for flexible policy (Profile Type=Flexible Policy) with a particular Zone/Trunk Group.

If Flexible Policy Adapter Profile is provisioned both at the trunk group and zone levels, the trunk group’s profile takes precedence. If Input Adapter Profile is configured, it is applied first to manipulate the PDU and then Flexible Policy Adapter Profile rules are applied on the manipulated PDU.

Unable to render {include} The included page could not be found.

To Delete Zone

To delete any of the created Zone, click the radio button next to the specific Zone which you want to delete.

Zone Highlighted

Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Zone Delete Confirmation

Click OK to remove the specific Zone from the list.

 

  • No labels