You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Back to Table of Contents

Back to CLI Configure Mode

Back to Profiles - CLI

Back to Signaling - CLI

Back to IP Signaling Profile - CLI

Back to IP Signaling Profile - H.323 - CLI

In this section:

This section lists CLI commands to configure ingress IP attributes.

Command Syntax

 

% set profiles signaling ipSignalingProfile DEFAULT_H323 
	ingressIpAttributes 
	flags 
		convertProgressToAlert <disable | enable> 
		dontSendFacilityMessage <disable | enable> 
		refuseFastStartProposal <disable | enable> 
		send183OnInitiatingDisconnectTreatment <disable | enable> 
		sendFastStartResponseInCp <disable | enable>

 

Command Parameters

The IP Signaling Profile H.323 Ingress IP Attributes flags are shown below:

IP Signaling Profile H.323 Ingress IP Parameters

Parameter

Length/Range

Description

convertProgressToAlert

N/A

Set this flag to convert Progress messages to Alert messages when communicating to endpoints that have difficulty with Progress messages.

  • disable (default)
  • enable

dontSendFacilityMessage

N/A

Set this flag to prevent sending Facility messages to endpoints that do not tunnel and have difficulty processing Facility messages.

  • disable (default)
  • enable

refuseFastStartProposal

N/A

When this flag is set, 

Unable to show "metadata-from": No such page "_space_variables"
does not include FastStart proposal in early media calls. Instead, it relies on H.245 procedure to complete media setup. When cleared, 
Unable to show "metadata-from": No such page "_space_variables"
always includes fast start proposal in SETUP message for early media calls.

  • disable (default)
  • enable

send183OnInitiatingDisconnectTreatment

N/A

Enable flag to send a 183 message on initiating a disconnect treatment.

  • disable (default)
  • enable

sendFastStartResponseInCp

N/A

When this parameters is used, the 

Unable to show "metadata-from": No such page "_space_variables"
sends a FastStart response message in Call Proceeding messages.

  • disable (default)
  • enable

 

 

  • No labels