You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

 

This window displays SBC Daughter Board (DB) module status details.

Note

Not applicable to the SBC Software Edition.

On the

Unable to show "metadata-from": No such page "_space_variables"
 main screen, go to Monitoring > System > Category: Hardware Status > Daughter Board Status. The Daughter Board Status window is displayed.

Daughter Board Status

 

The following fields are displayed:

system daughterBoardStatus Parameters

 

Parameter

Description

Server NameServer name.
Slot Specifies the slot associated with the DSP board.
Daughter Board Id

Daughter board identifier.

Unable to show "metadata-from": No such page "_space_variables"
:

  • SPS100 – SBC 5x00 SPS100 module
  • DB0 – SBC 5x00 SPS100DB 0 module
  • DB1 – SBC 5x00 SPS100DB 1 module
  • DSP20 – SBC 5x10 DSP20 module
  • DSP25 – SBC 5x10 DSP25 module

Unable to show "metadata-from": No such page "_space_variables"
:

  • FRU_DSP1 – SBC 7000 DSP-LC slot 1

  • FRU_DSP2 – SBC 7000 DSP-LC slot 2

  • FRU_DSP3 – SBC 7000 DSP-LC slot 3

  • FRU_DSP4 – SBC 7000 DSP-LC slot 4

PresentIndicates if the module is present or not.
Product NameIdentifies manufacturer module name (if present).
Serial Num

Identifies the serial number of the module (if present).

The maintenance fields Image Load Failure Count and Fpga Version  do not apply to SPS100 cards.
Part Num The part number of the module (if present).
Operational Status Operational state of daughter board.
  • disabled – Card is disabled.
  • dryup – Card is enabled but in the process of drying up. Once completed, card will be set to ‘disabled’.
  • enabled – Card is enabled.
  • failed – If a DSP2x or DSP-LC module fails to boot over three consecutive tries (typically due to a hardware failure), it is taken out of service and marked as state “failed”. The rest of the system continues to boot normally, including any other DSP modules. The module failure is logged/alarmed with trap “sonusConnexIpSystemCESlotFailedNotification”. The slot remains in the failed state until the module is disabled and re-enabled once a replacement card is installed.
  • loading – Card is enabled but in the process of booting. Resources are not yet available. Once completed, card will be set to ‘enabled’.

  • locked – Slot capacity is locked out due to mismatch (with “preserveRedundancy” configured).

For 5x00 systems, only the “enabled” state displays in the results.
Image Load Failure Count  Number of module boot failures since the last successful module boot, for use during diagnostic testing of a potentially failed module.
Fpga Version  A card’s programmed firmware version (using FPGA build date).

By default only ten entries are displayed in a view. You can choose the number of entries to be displayed under the Show entries drop down box. 

  • No labels