In this section:
This object allows you to configure
Unable to show "metadata-from": No such page "_space_variables"
management static routes. This object specifies the gateway to which you wish to direct traffic from your Packet, Management, or Link Interface. In effect, this object allows you to add, change, and delete gateways (NEXTHOPs) to these interfaces. Interfaces and static routes combine to form the IP routing table for your network. This table must ultimately provide a route to each potential call destination IP address.To View Mgmt Static Route
On SBC main screen, go to Configuration > System Setup > Mgmt Static Route. The Mgmt Static Route window is displayed.
System Setup - Mgmt Static Route
To Edit Mgmt Static Route
To edit any of the Mgmt Static Route in the list, click the radio button next to the specific Mgmt Static Route name.
System Setup - Mgmt Static Route Highlighted
The Edit Selected Mgmt Static Route window is displayed below.
System Setup - Mgmt Static Route Edit
Make the required changes and click Save to save the changes.
To Create Mgmt Static Route
To create a new Mgmt Static Route, click New Mgmt Static Route tab on the Mgmt Static Route List panel.
System Setup - Mgmt Static Route Fields
The Create New Mgmt Static Route window is displayed.
System Setup - Mgmt Static Route Create
Enter all the required fields. You can click Show only required fields at the left hand bottom of the panel to view and enter only the required fields to create a new Mgmt Static Route.
The following fields are displayed:
System Setup - Mgmt Static Route Parameters
Parameter | Description |
|---|---|
| Specifies the range of the number of past interval that can be configured for retrieving the statistics data. Must be 1-12 (intervals), default is 4. |
| The IP prefix of this static route entry. |
| The IP address of the next system enroute to the destination. The 32-bit IP address of a default subnetwork gateway in dotted decimal form (for example 128.127.50.224). Default value is 0.0.0.0. |
| Specifies the IP Interface Group Name. |
| Specifies the IP Interface name. |
| Specifies the route preference. Route preferences are used by the lookup engine to decide the route entry to use if multiple equivalent routes exist to the same destination. By default, route preferences on active interfaces take the values:
|
Static and OSPF routes on standby interfaces have a value of 250 added. The higher the route preference, the less likely the route is to be used. This value must be in the range 1-255 for active interfaces and the corresponding entries on the standby will have a value of 250 added.
To Copy Mgmt Static Route
To copy any of the created Mgmt Static Route and to make any minor changes, click the radio button next to the specific Mgmt Static Route to highlight the row.
System Setup - Mgmt Static Route Highlighted
Click Copy Mgmt Static Route tab on the Mgmt Static Route List panel.
System Setup - Mgmt Static Route Fields
The Copy Selected Mgmt Static Route window is displayed along with the field details which can be edited.
System Setup - Mgmt Static Route Copy
Make the required changes to the required fields and click Save to save the changes. The copied Mgmt Static Route is displayed at the bottom of the original Mgmt Static Route in the Mgmt Static Route List panel.
To Delete Mgmt Static Route
To delete any of the created Mgmt Static Routes, click the radio button next to the Mgmt Static Route which you want to delete.
System Setup - Mgmt Static Route Highlighted
Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.
System Setup - Mgmt Static Route Delete Confirmation
Click Yes to remove the specific Mgmt Static Route from the list.
Overview
Content Tools