Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel

In this section:

Table of Contents
maxLevel2

...

Use this screen to configure the DBL Aggregate Rej policer.

To View and Edit DBL Aggregate Rej

On the SBC main screen, go to Configuration > System Provisioning > Security Configuration >Sip Cac SIP CAC Profile > DBL Aggregate Rej.

Select the desired Sip Cac SIP CAC Profile from the drop-down list to view its respective DBL Aggregate Rej parameters.

The DBL Aggregate Rej window is displayed.Figure 1: Security Configuration - Sip Cac Profile - DBL Aggregate Rej

The following fields are displayed:


Table 1: DBL Aggregate Rej Parameters:

Parameter

Length/Range

Description

Ingress Burst
Size

1-10000

Specifies the maximum burst size for ingress aggregate message.

The value range from 1 - 10000. The default value is 10.

Default = 1

Ingress Rate

1-1000, or unlimited

Specifies the maximum ingress aggregate message rate in aggregate messages per period.

The

value range from 1 - 1000 or

default value is unlimited.

Ingress Rate
Period

1-10

Specifies the

time

period (in seconds) over which the ingress aggregate message rate applies.

The value range from 1 - 10 seconds.

Default = 1

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.