By default, you can only configure the settings of your SBC SWe Edge through the Active instance. The Standby instance is mainly in a view-only permissions mode unless otherwise specified. | Task | Subtask | WebUI Path | WebUI Changes |
|---|
System
| HA Software Upgrade | Anchor |
|---|
| HA Software Upgrade |
|---|
| HA Software Upgrade |
|---|
|
| Tasks > System > HA Software Upgrade | | Backup/Restore Config | Tasks > System > Backup/Restore Config |
| Reboot SBC Edge | Tasks > System > Reboot SBC Edge | - Reboot SBC Edge is available on both the Active and the Standby instances.
- The warning message, "This operation will stop all the calls and reboot the system." is removed from the Active and the Standby instances.
| SBC Edge Factory Default - Factory Default | Tasks > System > SBC Edge Factory Default | Standby instance only supports the - Active and the Standby instances both support the Factory Default option.
| Import Partial Configuration | Tasks > System > Import Partial Configuration |
| Import/Export Configuration Items
| Import Local/Passthrough Auth Table | Tasks > Import/Export Configuration Items > Import Local/Passthrough Auth Table | - The task of Import/Export Configuration Items and its subtasks are removed from the Standby instance.
| Transformation Tables | Tasks > Import/Export Configuration Items > Transformation Tables | SIP Message Rule | Tasks > Import/Export Configuration Items > SIP Message Rule | SBC Easy Setup
| Easy Configuration Wizard | Tasks > SBC Easy Setup | | Media System Configuration | Tasks > SBC Easy Setup |
| Certificates | Tasks > SBC Easy Setup |
| | IP/Protocols | Modify Ethernet IP Address | Tasks > IP/Protocols |
| | BroadSoft Provisioning | Auto Configuration | Tasks > BroadSoft Provisioning |
|
|