Page History
Panel | ||||
---|---|---|---|---|
In this section:
|
Info | ||
---|---|---|
| ||
Related articles: |
To register to alternate SIP server, use either of the following procedure:
Table of Contents | ||||
---|---|---|---|---|
|
Note |
---|
If both of the above configurations are present, the SIP Trunk Group Configuration takes precedence over the IPSP Configuration. |
IPSP Configuration
To configure an alternate SIP server using IPSP configuration, perform the following steps:
- Configuring Path Check for IP Address or FQDN
- Configuring IP Signaling Profile
- Configuring the Internal Expires Timer
- Configuring Registrar Recovery flags in IP Signaling Profile
Table of Contents | ||||
---|---|---|---|---|
|
Configuring Path Check for IP Address
or FQDN
Note |
---|
This feature requires Pathcheck support using OPTIONS Ping and ARS static blacklisting to detect the reachability of a particular IP/FQDN. |
For IP Address
Code Block | ||
---|---|---|
| ||
set profiles services pathCheckProfile PATH1 protocol sipOptions sendInterval 60 replyTimeoutCount 1 recoveryCount 1 set addressContext default zone ZONE_AS ipPeer PEER_AS ipAddress 10.54.80.94 ipPort 6274 set addressContext default zone ZONE_AS ipPeer PEER_AS pathCheck profile PATH1 state enabled |
For FQDN
Code Block | ||
---|---|---|
| ||
set profiles services pathCheckProfile PATH1 protocol sipOptions sendInterval 60 replyTimeoutCount 1 recoveryCount 1 set addressContext default zone ZONE_AS ipPeer PEER_AS1 policy sip fqdn example.com fqdnPort 6274 set addressContext default zone ZONE_AS ipPeer PEER_AS1 pathCheck profile PATH1 hostName abc.example.com hostPort 6274 state enabled |
Configuring IP Signaling Profile
Configuring IP Signaling ProfileCode Block | ||
---|---|---|
| ||
set addressContext default zone ZONE_AS sipTrunkGroup TG_SIPART_AS policy signaling ipSignalingProfile DEFAULT_SIP |
Configuring the Internal Expires Timer
Code Block | ||
---|---|---|
| ||
set addressContext default zone ZONE_AS sipTrunkGroup TG_SIPART_AS signaling registration insideExpiresMinimum 3600 |
Configuring Registrar Recovery flags in IP Signaling Profile
Code Block | ||
---|---|---|
| ||
set profiles signaling ipSignalingProfile DEFAULT_SIP commonIpAttributes registrarRecovery registerToAlternateOnPrimaryDown enable revertToPrimaryOnRecovery enable deRegisterAlternateOnPrimaryRecovery enable overrideInternalExpiresTimer enable |
Note |
---|
|
Manual Registration Refresh
Use the The CLI request queryPsxOnNextRefreshRegister
command is used to commandto force a PSX query on a subsequent refresh REGISTER. This enables new routing information configured in the PSX to reflect in the SBC when registrations are active for a long period of time.
Note |
---|
Any new registrations that are received after the issuing this command is executed are not affected by this the command. |
Code Block | ||
---|---|---|
| ||
request addressContext default zone ZONE_AS sipTrunkGroup TG_SIPART_AS cmds queryPsxOnNextRefreshRegister newRegistrarIndex 1 request addressContext default zone ZONE_AS sipTrunkGroup TG_SIPART_AS cmds queryPsxOnNextRefreshRegister newRegistrarIndex 1 overRideInternalExpires enable registrarIpAddress 10.54.80.94 request addressContext default zone ZONE_AS sipTrunkGroup TG_SIPART_AS cmds queryPsxOnNextRefreshRegister newRegistrarIndex 1 overRideInternalExpires enable registrarFqdn abc.example.com |
Note |
---|
|