Versions Compared

Old Version 3

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

These fields apply if you selected Twilio SIP Trunk in Step 1 - Select Scenario. 

Include PageNot_Applicable_to_CloudNativeNot_Applicable_to_CloudNative

FieldDescription
Border Element ServerThe FQDN or IP address of the Remote Peer service provider.
ProtocolThe IP protocol used for sending and receiving SIP messages between the SBC and the Border Element Server. Valid entries: UDP or TCP.
Port Number

The port number for the SIP server used to send and receive SIP messages between the SBC and the Border Element Server.

Use Secondary Border Element ServerEnables or disables the secondary Remote Peer service provider configured. 
Secondary Border Element ServerSpecifies the Secondary Border Element Service provider. Valid entry: IP Address or FQDN. This field is available only when Use Secondary Border Element Server is Enabled.
ProtocolThe Protocol used for communicating with the Secondary Border Element Server. Valid entry: UDP or TCP. This field is available only when Use Secondary Border Element Server is Enabled.
Port NumberThe Port Number is used for sending and receiving messages between SBC and the Secondary Border Element server. This field is available only when Use Secondary Border Element Server is Enabled.
Signaling/Media Source IPSelect the external (Internet-facing) IP address for the server that handles routing of messages for signaling and media.
Outbound NAT IP

Allows the SBC to be placed behind a NAT device, and uses the IP of the NAT device for all outgoing messages. If this field is set to Enable, the Public IP address field configuration is required. Valid selections:

  • Enable: Network Address Translation is used for the NAT device's Public IP address.
  • Disable: Network Address Translation address translation is not used.

NOTE: This field is required when the SBC interface has a private IP and the NAT device is using a public IP. For details on configuring an SBC behind the NAT, refer to Configuring the SBC Edge for NAT Traversal.

...