Page History
To reduce the risk of equipment damage, the
Spacevars | ||
---|---|---|
|
Prevention of ESD Damage
To prevent ESD damage observe the following precautions:
- Wear an ESD grounding strap connected to a proper ground when handling modules.
- Keep boards in their antistatic protection bags until you are ready to install them.
- Do not touch pins, leads, or solder connections on the boards.
- Handle modules only by their edges, ejector handles, or stiffener rails.
- Store and ship modules in antistatic protection packaging.
ESD Ground Connection
The SBC 1000/2000 Series equipment provide an ESD ground connection in the form of a grounding plug for installation and removal of user-serviceable components. Use an ESD wrist strap attached to the grounding plug located on the rear of your SBC 1000/2000 unit.
ESD Ground Connection Wrist Strap
SBC 2000 ESD Connection
For information about where to plug in the ESD grounding device at the chassis, see Ribbon SBC 2000 Hardware Specifications.
The ESD wrist strap must be attached to the grounding plug located on the rear of your SBC 1000/2000 unit. The figure below illustrates the location of the ESD grounding plug.
Location of the ESD Plug on the Ribbon SBC 2000 Chassis Rear Panel
SBC 1000 ESD Connection
The
Spacevars | ||
---|---|---|
|
Location of the Grounding Screw on the Ribbon SBC 1000 Chassis Rear Panel
Pagebreak |
---|
Overview
Content Tools