Page History

To upgrade the inactive partition:

1. In the WebUI, click the Settings tab.

2. In the left navigation pane, go to System > Software Management > Application Partitions.

   Caption
   0 Figure 1 Partitions Table
   Image Modified

   
   

3. Make note of the inactive partition number you are upgrading the firmware to (the table entry listed without a tick mark under the 'Active Partition' column).
   This will be important towards the end when verifying the last upload status of the inactive partition.

4. Click the Upload Firmware link located on the top right left hand side of the pane - a popup window will be dispatched:

    

   Pagebreak

   Caption
   0 Figure 1 Upload Firmware
   Image Modified

    

   
   

5. Under Select File, click the Browse button and select the

   Spacevars
   0 company

   SBC 1000/2000 firmware file listed in the general SBC 1000/2000 Upgrade guide to upload. Click OK. Do not close or navigate away from the browser window or you may  receive partial results.   
   

   Caption
   0 Figure 1 Select File
   Image Modified

    
   

   
   

6. Throughout the upload process, the web interface displays update messages to indicate the progression of the upgrade of the inactive partition, as shown below. (If you navigate to this view from another browser, it will also display the progress.)
   

   Caption
   0 Figure 1 Upgrade Progress
   Image Modified Image Modified Image Modified Image Modified Image Modified Image Modified

    
    

   
   

7.  Once the upgrade has completed, click the X in the corner of the box to dismiss the popup window.
   

8.  On the partition page, verify the Last Upload Status associated with the inactive partition is listed as Success.