Page History

...

This article describes the steps necessary to configure a 

Spacevars
0 product

to employ the SIP Timer Functionality in the depicted topology:

Configuration

The configuration process comprises of two overall steps:

...

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to SIP > SIP Profiles
3. Select the relevant SIP Profile.

4. Configure the Session Timer as shown in the figure below.
   Important: The Offered Session Timer value must be equal to or greater than the Minimum Acceptable Value.

   Panel

   borderStyle	none

   Caption

   0	Figure
   1	Configure Session Timer

   Image Modified

Signaling Group

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Signaling Groups > (relevant SIP Signaling Group).
3. Select the SIP Profile configured above from the SIP Profile selection list.

4. Click Apply.

   Panel

   borderStyle	none

   Caption0Figure1Apply Configured SIP Profile

   
   

    

   Image Modified

   
   

Call Flow

After having applied the configuration changes, in the call flow, the 

Spacevars
0 product

supports the UPDATE and INVITE  methods for changing the media capabilities. Session Timer (RFC 4028) uses the INVITE or UPDATE as a mechanism for a periodic refresh of SIP sessions.

...

You can verify this using the Log Exchange utility — the following diagram depicts a 

Spacevars
0 product

to Lync/SBA call with the Session Timer enabled and in effect:

...

borderStyle	none

...

SBC 1000/2000 to Lync/SBA Call

Image Modified

...

pagebreak