Page History

...

1. In the WebUI, click the Settings tab.

2. In the left navigation page, access System > Node-Level Settings. The Node-Level Settings page is displayed.

3. Configure the NTP and DNS Servers with network-specific data.

4. Leave all other parameters as default.

5. Click Apply.

   Caption
   0 Table 1 TLS Configuration - Example Values
   Parameter Example Value Host Name aepsite6 Domain Name SonusMS01.com Use NTP Yes NTP Server Specifies the FQDN, IPv4, or IPv6 address of the NTP server. If the host name is supplied, the SBC uses the DNS to connect to the NTP server. Use Primary DNS Yes Primary Server IP XXX.XXX.XX.XXX

   
   

   Caption
   0 Figure 1 Node-level Settings - Example
   Image Modified

   
   

Configure Logical Interface

...

1. In the WebUI, click the Settings tab.

2. In the left navigation pane, go to Node Interfaces > Logical Interfaces.

3. Configure the parameters as shown below (example values are shown in the table; configure as per your network requirements). For details on field descriptions, refer to Configuring and Modifying Logical Interfaces.

4. Leave all other parameters as default.

5. Click Apply.
   

   Pagebreak

   Caption
   0 Table 1 Logical Interfaces Configuration - Example Values
   Parameter Example Value Alias To Microsoft Phone 5 Description Interface to Interconnect with Microsoft Phone System Admin Interface Enable IP Assign Method Static Primary Address <Public IP of your SBC> (in the example 192.168.211.80) Primary Netmask <Mask of Public Interface of your SBC> (in the example 255.255.255.0)

   
   

   Caption
   0 Figure 1 Logical Interfaces - Example
   Image Modified

   
   

Use Easy Config Wizard

...