Page History

...

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Signaling Groups.

3. Select the Signaling Group used for Microsoft Teams Direct Routing.

4. From the RTCP Multiplexing drop down list, select Enable. 

   Caption
   0 Figure 1 Enable RTCP Multiplexing

   
   

5. From the ICE Support drown drop down list, select Enable.

6. From the ICE Mode drop down list, select Lite.

   Caption
   0 Figure 1 Enable ICE Support

   Note
   Before configuring Outbound NAT Traversal, obtain the Public IP address for your network (the Public IP address specified in the screen graphic is an example only).

7. For deployment behind a NAT only:
   
   1. From the Outbound NAT Traversal drop down list, select Static NAT.

   2. From the NAT Public IP (Signaling/Media) drop down list, enter the Public IP Address assigned on this media port (the Public IP used in the screen is an example only; use the Public IP for your network). 

      Caption
      0 Figure 1 Enable NAT

8. Click Apply.

...