Page History

This section describes the method to upgrade the 

The following procedure describes how to upgrade the firmware from the BMC web GUI.

1. Log on to the BMC using the default credential:
   Username: <username>
   Password: <default password>
SBC BMC GUI.


   Caption
   0 Figure 1 BMC Login Screen

   The BMC main screen is displayed.

   Caption
   0 Figure 1 BMC Main Screen

2. Click Firmware Update. The Firmware Update screen is displayed.

   Caption
   0 Figure 1 Firmware Update Screen

3. Click Browse, and from the Open dialog browse to and select select the firmware-7X00-V<release>.img firmware image. To determine the exact firmware version, see refer to SBC Release Information for guidancethe current release notes.
   
   The chosen file displays next to the Browse button.

   Caption
   0 Figure 1 Browsing Firmware Image

4. Click Upload.

   Infonote
   title Note
   The firmware image is a 26MB 26 MB file and takes few minutes to upload based on the network.

5. Once the upload is completedcompletes, the Firmware Update Update screen displays the firmware images and its detailsversions.

   Caption
   0 Figure 1 Uploading Firmware Image

   Info
   Note
   title Note
   In the previous screen, if both  The above screen displays the list of entities, which are updated. If both the Old Version and New Version are same, then the update status displays as "No".

6. Click Confirm to continue. The upgrade progress bar displays on the screen.

   note

   Info
   title Note
   This is a service-affecting procedure and will power off the host side of the SBC.

   Include Page
   _Host Shutdown Failure During BMC Upgrade _Host Shutdown Failure During BMC Upgrade

7. After the firmware upgrade is completedcompletes, the following screen dialog displays. The BMC automatically restartsClick OK to close the message.

   Caption
   0 Figure 1 Completing Firmware Upgrade

   note

   Info
   title
   Note
   Once the upgrade completes, the BMC and host reboots reboot automatically. Verify that the SBC starts and sync with its peer server before proceeding further.

8. Close the SBC BMC GUI.

9. Clear the browser cache and log on to the BMC GUI again.

10. Log on to the BMC using the default credentials:
    Username: <username>
    Password: <default password>
     SBC BMC GUI again.
    The SBC BMC compels prompts you to change the password after a successful upgrade.

    Infonote
    title Note
    This change is applicable only when the BMC is upgrade upgraded to version 03.13.00 and later versions.

    Caption
    0 Figure 1 Change Default Password window

11. Click OK to proceed. The User Management window is displayed.

    note

    Info
    title
    Note
    You have an option to cancel the action. If cancelledcanceled, the password remains the same as the default password and you are allowed to continue to work on the BMC. However, the warning message is displayed again on you your next login to BMC. This reminder continues till until the password is changed. To know more about how to successfully change the SBC BMC password, refer to Changing the BMC PasswordRefer to Changing the BMC Password for the procedure to change the password.

12. Verify the upgraded version in the BMC main screen and ensure the BIOS and BMC versions match the versions listed in the release notes.